Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Stud 6x33x 1.00 thread
Stud 6x33x 1.00 thread
No customer reviews for the moment.
Part #: 1601104C
Long Wheel Studs, M14-1.5 on both ends, Set of 5
Application:Part #: 211827905
This bracket holds the license plate to the car.
Application:Part #: 1115456
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily.
Application:Part #: 1827331
This extension allows you to run the deck lid spring when using the deck lid stand offs..
Application:Part #: 1411107
2" Narrowed Leaves for Link Pin, 1 Set (2 sets required)
Application:Part #: 6857650
Billet Deluxe Whip Antenna Mount for 1.5" Tubing
Application:Part #: 1411300AN
Narrowed Sway Bar for Narrowed, Adjustable Front Beam, Link Pin
Application:Part #: 211141025A
Clutch Cover, 12 volt 200mm, 9 spring
Application:Part #: 2129040
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 02069
These are the parts found in the distributor.
Application:Part #: 2847121A
This seal goes on the body of the bus, that the safari window closes against. Sold in pairs.
Application:Part #: 3251006
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 113141701F
This shaft holds the throw-out bearing in place.
Application:Part #: 151871409B
Rear Bow Base Seal for Convertible Top
Application:Part #: 311837657A
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
Application:Part #: N120121
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:
Stud 6x33x 1.00 thread