Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These rubber mounts hold the transmission in place.
These rubber mounts hold the transmission in place. Check your old mounts while the transmission is in the car. To check the rear mounts, take a pry bar and place it between the saddle and bellhousing and pry up. If the transmission moves, the rear mounts are bad. To check the front mount, place the pry bar between one of the forks and the transmission and pry up. If the nose of the transmission moves, replace the front mount. Stick shift movement on acceleration and deceleration are symptoms of a broken front mount. Note: Don't use solid mounts on the street. The noise that's transmitted through the tunnel will drive you crazy.
Bug (Type 1): 73-79
Type 3: 73-74
Ghia: 73-74
Off-Road: 73-
No customer reviews for the moment.
Part #: 001301207
Nose Cone Bushing, Rear, Late
Application:Part #: 113517191
Swing Axle Fulcrum Plates
Application:Part #: 1301050
These straps are a good idea if you have a car with a big engine.The rear strap keeps the bell housing from twisting and the front strap keeps the nose of the transmission from breaking the front mount.We highly recomend that you use these in conjunction with the urethane transmission mounts.
Application:Part #: 1311123
This steel thrust plate stops movement of the main shaft bearing and aids in the keepin the alignment of the gears on the main and pinion shafts.
Application:Part #: 1301265L
Urethane Front Transmission mount with Hardware
Application:Part #: 111398003
Transmission gasket set.
Application:Bug (Type 1); -60
Bus (Type 2); -59
Ghia; -60
Part #: 111301155
This is the bushing between the bellhousing of the transmission and the starter.
Application:Part #: N122391
Transmission Cradle Bolt Washer
Application:Part #: 1301049
These straps are a good idea if you have a car with a big engine.The rear strap keeps the bell housing from twisting and the front strap keeps the nose of the transmission from breaking the front mount.We highly recomend that you use these in conjunction with the urethane transmission mounts.
Application:Part #: 111301289B
This boot goes around the nose cone to seal up the hole where it comes through the pan.
Application:Part #: 113311541C
Transmission Shift Lever (Hockey Stick)
Application:Part #: 001301083B
This seal keeps the fluid in the converter.
Application:Part #: 001301209A
Nose Cone Seal Holder
Application:Part #: 6501141
These retainers help stiffen the plates that bolts the tubes to the trans.
Application:Part #: 113311123A
This is the main culprit of a noisy transmission.
Application:Part #: 311301265A
These rubber mounts hold the transmission in place.
Application:
These rubber mounts hold the transmission in place.
