Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This rod drives the fuel pump.
This rod drives the fuel pump. Used ones are fine; very rarely do they go bad. There are two different sizes. The short one is for pumps that are tilted and the long ones are for the rest. Short rods and tilted pumps are found on engines with alternators. Note: The point goes down.
Bus (Type 2): 1700-1800
No customer reviews for the moment.
Part #: 113127311
These stock pumps pump fuel into the carburetor.
Application:Part #: 1127022BL
Billet Fuel Pump Block off, Blue
Application:Part #: 1129700
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 1127109
This is a brass tee for dual carbs.
Application:Part #: 1127027
This regulator adjusts the fuel pressure to you carburator.
Application:Part #: 022129707F
The Intake Manifold Gasket (2 are required per engine).
Application:Part #: 1129601EL6
This is a replacement air cleaner for the Weber IDF.
Application:Part #: 113127521A
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
Application:Part #: N138211
These are the gaskets used between the intake manifold and the cylinder head.
Application:Part #: 021127303A
The fuel pump sits on this little stand and it's also the guide for the push rod.
Application:Part #: N138231
These are the gaskets used between the intake manifold and the cylinder head.
Application:Part #: 1129729BK
These boots are better than stock.
Application:Part #: 1129025
This is a new aftermarket UNIVERSAL intake manifold for Dual Port Engines. You can use a 30 Pict1 or 34Pict3 Carburetor. We have had major icing problems with this part and prefer stock manifolds.
Application:Part #: 1127022RD
Billet Fuel Pump Block off, Red
Application:Part #: 1129604
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 1129718
These gaskets are for upright dual port engines.
Application:
This rod drives the fuel pump.
