Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is a good, cheap dual carburetor kit for a 1600cc motor.
This is a good, cheap dual carburetor kit for a 1600cc motor. What we don't like is the throttle bushings wear out over time and you need to change the fuel hose it comes with to a German hose. If you need different jet see carburetor parts. They take stock solex idle jets and main jets.
Bug (Type 1): 1600
Bus (Type 2): 1600
Ghia: 1600
Thing: 1600
Off-Road: 1600
No customer reviews for the moment.
Part #: 111127591A
Fuel Line Grommet 8mm
Application:Part #: 1129616
This air cleaner is a sealed unit; the top and bottom do not come off, but they're washable.
Application:Part #: 113127313
These stock pumps pump fuel into the carburetor.
Application:Part #: 1129709
This pair of aluminum end castings are for use with a center section manifold.
Application:Part #: 1129604
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 1129729
These boots can be put on without taking the intake manifold apart and should be used only in an emergency.
Application:Part #: 1127112
This regulator adjusts the fuel pressure to you carburator.
Application:Part #: 113129729BS
These boots connect the intake manifold with the end casting on a stock dual port 1600cc engine. Two are required boots are sold individually.
Application:Part #: 1127110
This is a brass tee for dual carbs.
Application:Part #: N138211
These are the gaskets used between the intake manifold and the cylinder head.
Application:Part #: 1129717
These gaskets are for upright dual port engines.
Application:Part #: 043129707
Intake Manifold Block
Application:Part #: 111127521A
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
Application:Part #: 1127106ALM
This is stainless steel braided fuel line.
Application:Part #: 1129608EL
This air cleaner takes the place of a stock air cleaner.
Application:
This is a good, cheap dual carburetor kit for a 1600cc motor.
