Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:These stock pumps pump fuel into the carburetor.
These stock pumps pump fuel into the carburetor. We prefer the 025B pump over all the other pumps; however it is no longer avaible. The next best is the 025D. We don't recommend aftermarket electric pumps, because if you get in an accident and there is a fire, the pump continues to feed it. Note: Before installation, put a dab of grease on the foot that the rod rides on.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Type 3: 40hp-1600
Ghia: 40hp-1600
Thing (Type 5): 40hp-1600
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 1129622
Round Gauze Rubber Flange Air Cleaner for Stock VW Carb 2" Neck 5 1/4" Diameter X 2 3/4" High
Application:Part #: 1129612
Single Air Cleaner
Application:Part #: 1127022RD
Billet Fuel Pump Block off, Red
Application:Part #: 1129616
This air cleaner is a sealed unit; the top and bottom do not come off, but they're washable.
Application:Part #: 1129025
This is a new aftermarket UNIVERSAL intake manifold for Dual Port Engines. You can use a 30 Pict1 or 34Pict3 Carburetor. We have had major icing problems with this part and prefer stock manifolds.
Application:Part #: N138211
These are the gaskets used between the intake manifold and the cylinder head.
Application:Part #: 113127303
The fuel pump sits on this little stand and it's also the guide for the push rod.
Application:Part #: 1129708
This pair of aluminum end castings are for use with a center section manifold.
Application:Part #: 1129809K
Kadron Air Cleaner Base Gasket (Pair)
Application:Part #: 61316
These stock pumps pump fuel into the carburetor.
Application:Part #: 1127108ALF
This is stainless steel braided fuel line.
Application:Part #: 1129601BIL
This is a replacement air cleaner for the Weber IDF.
Application:Part #: 1129601HD
This is a replacement air cleaner for the Weber IDF.
Application:Part #: 1129717
These gaskets are for upright dual port engines.
Application:Part #: 111127521A
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
Application:Part #: 1127110
This is a brass tee for dual carbs.
Application: