Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These gaskets are for upright dual port engines.
These gaskets are for upright dual port engines. Never use any type of sealer on these gaskets. Stock, metal dual port gaskets are junk and only fit well in the garbage can. Sold in pairs
Bug (Type 1): 1600
Bus (Type 2): 1600
Type 3: 1600
Ghia: 1600
Thing: 1600
Race/Off-Road: 1600
No customer reviews for the moment.
Part #: 1129605EL
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 113127025BCD
These stock pumps pump fuel into the carburetor.
Application:Part #: 1129622
Round Gauze Rubber Flange Air Cleaner for Stock VW Carb 2" Neck 5 1/4" Diameter X 2 3/4" High
Application:Part #: 111127511A
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
Application:Part #: 111127531A
6mm Fuel Line Ferrule
Application:Part #: 1129601BIL
This is a replacement air cleaner for the Weber IDF.
Application:Part #: 1127022
This block off is used in conjunction with electric fuel pumps and mounts in place of the manual fuel pump.
Application:Part #: 113129710D
Dual Port Manifold End Casting - Right
Application:Part #: N138211
These are the gaskets used between the intake manifold and the cylinder head.
Application:Part #: 1127109
This is a brass tee for dual carbs.
Application:Part #: 1129710
EMPI Single HPMX/IDF Manifold for Type 1 engines
Application:Part #: 113129717LRG
Dual Port Gaskets without Pin Holes
Application:Part #: 1127103ALM
This is stainless steel braided fuel line.
Application:Part #: 311133261A
These o-rings should be replaced whenever you replace a fuel injector, or if they are old and cracked.
Application:Part #: 113127025G
These stock pumps pump fuel into the carburetor.
Application:Part #: 1129025
This is a new aftermarket UNIVERSAL intake manifold for Dual Port Engines. You can use a 30 Pict1 or 34Pict3 Carburetor. We have had major icing problems with this part and prefer stock manifolds.
Application:
These gaskets are for upright dual port engines.