Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank. It has two 90 degree bends where it comes out of the rear tin. It's function is to keep the fuel away from the heater box. Most people don't replace this, but should. We see a lot of engine fires because of a bad metal line or a flex fuel line run all the way to the pump. Note: Make sure you have a grommet in the rear tin so that the tin doesn't rub a hole in the line.
Bug (Type 1): 36hp
Bus (Type 2): 36hp
Ghia: 36hp
No customer reviews for the moment.
Part #: 1129701
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129609EL
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 1129616
This air cleaner is a sealed unit; the top and bottom do not come off, but they're washable.
Application:Part #: 1127109ALM
This is stainless steel braided fuel line.
Application:Part #: 1129709
This pair of aluminum end castings are for use with a center section manifold.
Application:Part #: 1129608
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 1129601
This is a replacement air cleaner for the Weber IDF.
Application:Part #: 1129611
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: N138211
These are the gaskets used between the intake manifold and the cylinder head.
Application:Part #: 1127027
This regulator adjusts the fuel pressure to you carburator.
Application:Part #: 113127307A
This rod drives the fuel pump.
Application:Part #: 043133241
These two boots connect the intake manifold with the end casting on a stock dual port 1600cc engine.
Application:Part #: 111127591
Fuel Line Grommet 6mm
Application:Part #: 1129809K
Kadron Air Cleaner Base Gasket (Pair)
Application:Part #: 1127101
Hose Clamp For 7mm Hose
Application:Part #: 61316
These stock pumps pump fuel into the carburetor.
Application:
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
