Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank. It has two 90 degree bends where it comes out of the rear tin. It's function is to keep the fuel away from the heater box. Most people don't replace this, but should. We see a lot of engine fires because of a bad metal line or a flex fuel line run all the way to the pump. Note: Make sure you have a grommet in the rear tin so that the tin doesn't rub a hole in the line. This line has the correct bends in and fits.
No customer reviews for the moment.
Part #: 113198729BS
Dual Port Installation Kit-Red
Application:Part #: 1127101S
This is stainless steel braided fuel line.
Application:Part #: 1129607
This air cleaner takes the place of a stock air cleaner.
Application:Part #: VCP12
This is a rubber plug that is used to plug off vacuum.
Application:Part #: 1129611EL
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: N138231
These are the gaskets used between the intake manifold and the cylinder head.
Application:Part #: 1127022RD
Billet Fuel Pump Block off, Red
Application:Part #: 113127521A
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
Application:Part #: 0280160200
Fuel Pressure Regulator for later air cooled Bugs and Buses
Application:Part #: 1129609
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 1129710
EMPI Single HPMX/IDF Manifold for Type 1 engines
Application:Part #: 113127303
The fuel pump sits on this little stand and it's also the guide for the push rod.
Application:Part #: 043129617A
Air Intake Boot for Fuel Injection
Application:Part #: 1129717
These gaskets are for upright dual port engines.
Application:Part #: 113127025D
These stock pumps pump fuel into the carburetor.
Application:Part #: 1129606
This air cleaner takes the place of a stock air cleaner.
Application:
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
