Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These fittings are used for the stainless steel hose.
These fittings are used for the stainless steel hose. Keep in mind there will be two fittings per connection. On the pipe thread end use teflon tape and don't "muscle" them. Turn them as tight as you can by hand, then one more full turn with a wrench.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1115431
This hex drive replacement plug is for the case relief spring(s).
Application:Part #: 311115107AHD
The oil pump is the heart of the engine, so it is very important to choose the right one.
Application:Part #: N110623
Some of the more common nuts you might need..
Application:Part #: 1129614F
This fitting can be used when routing your breather hose into your air cleaner.
Application:Part #: 1117106
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 111115175
Oil Screen 25HP engines thru 1 677 687
Application:Part #: 1115452
This stock oil filler and cap has been chromed.
Application:Part #: N115244
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 111115111B
The oil pump is the heart of the engine, so it is very important to choose the right one.
Application:Part #: 1117007SS
This is the high-temp/pressure hose wrapped with braided stainless steel.
Application:Part #: 1115183BL
This plate is made out of a solid piece of aluminum. Blue
Application:Part #: 111115451
This rubber collar goes around the dump tube that comes from the generator stand.
Application:Part #: 111115487
It caps the hole you are aiming at while pouring oil over everything else.
Application:Part #: 311115541
This boot goes on the end of the dump tube.
Application:Part #: 1117101ALF
These fittings are used for the stainless steel hose.
Application:Part #: 1115485CH
A stock cap that has been chromed for looks..
Application:
These fittings are used for the stainless steel hose.
