Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:There are 18 products.
Part #: 211711629B
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 211711629F
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 211711630C
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 211711629L
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 211711630L
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 211711629N
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 211711630N
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 211711647C
Center Defrost Cable, Controls dash defrost operation
Application:Part #: 211703523
Heater Cable Tube 2775mm
Application:Part #: 111711691
These little boots fit on the end of the heater tubes where the cables run through.
Application:Part #: 211711633
These little boots fit on the end of the heater tubes where the cables run through.
Application:Part #: 111129921
This is the barrel lock that locks the cable to the carb. It is also used on the Heater Cables
Application: