Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector. The collector is the most important part of a header. We suggest using a single quiet muffler on engines that have a stock carburetor or two, one-barrel carbs. You should run dual mufflers or one giant muffler on engines that have two, two-barrel carbs. If you're using the stock intake manifold, you'll need to drill out the heat riser stands on the header.
Bug (Type 1): 1500-1600
No customer reviews for the moment.
Part #: 1251210
These are two of the different types of exhaust nuts.
Application:Part #: 1251005MRG
Dual Quiet Muffler for Merged Header
Application:Part #: 1251262C
Paper gaskets are not our favorite, but if you are running larger ports, you have to use them.
Application:Part #: 1256092
Also called J-tubes, these tubes fit most header systems and replace the stock heater boxes, so you will lose your heat and defroster..
Application:Part #: 1251199
This is the 3-bolt gasket that goes between the muffler and the header.
Application:Part #: 1251006
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 1251203
This is the 3-bolt gasket that goes between the muffler and the header.
Application:Part #: 1251009
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 1251263
A stinger (depending on your motor combo) makes horsepower at 5K RPM and above.
Application:Part #: 1251000CC
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 1251211S
HD Racing Exhaust Nuts, 8mm-1.25 thread, 11mm head (Set of 8)
Application:Part #: 1251008H
1 5/8" Merged Flanged Header with Stinger (No Heater Boxes Included)
Application:Part #: 111251241A
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 1251210S
6 Point 8mm-1.25 thread Engine Nuts, Uses 10mm Wrench
Application:Part #: 1251159
Black Street Stinger with swivel flange
Application:Part #: 1251200
This kit comes with four flanges, two for the heater boxes and two for the header. Sold EACH, 2 required.
Application:
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
