Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine.
Bug (Type 1): 1600
Bus (Type 2): 1600
Type 3: 1600
Ghia: 1600
Thing: 1600
Race/Off-Road: 1600
No customer reviews for the moment.
Part #: 111199101
These are the bolts that hold the engine in.
Application:Part #: 113101221B
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: 043101129
This is the washer used under the nuts on cases that use an o-ring on the center main studs.
Application:Part #: N145431
Some of the most common studs you might need.
Application:Part #: 1101131B
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 111198005
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 1115107
This tray keeps the oil in the engine case from moving around too much, reducing oil starvation.
Application:Part #: 1101146
These cheater studs replace the head studs that have pulled from the case.
Application:Part #: 111101123
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings.
Application:Part #: 111199102
This nut came on all dual relief cases.
Application:Part #: 1101461KIT
This kit has the correct studs for a dual port engine to hold the heads on. 10mm
Application:Part #: 1115139
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 1101132
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 1198035C
Chromoly 8mm Head Stud Kit
Application:
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
