Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
It's possible to put a generator on an alternator stand but not the other way around.
It's possible to put a generator on an alternator stand but not the other way around. This stand holds either a generator or an alternator in place. Note: If you are buying this to change from 6v to 12v don't forget that you will also need to change the strap, pulley and rear generator tin.
Bug (Type 1): 1200-1600
Bus (Type 2): 1200-1600
Ghia: 1200-1600
Thing: 1200-1600
Race/Off-Road: 1200-1600
No customer reviews for the moment.
Part #: 111115421
Oil Relief Valve Spring 25-36 HP
Application:Part #: 111198003
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 1115107
This tray keeps the oil in the engine case from moving around too much, reducing oil starvation.
Application:Part #: 1101131
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 043101129
This is the washer used under the nuts on cases that use an o-ring on the center main studs.
Application:Part #: 1101031
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: 1101211
This chrome stand dresses up your engine.
Application:Part #: N104701
These are the bolts that hold the engine in.
Application:Part #: N145431
Some of the most common studs you might need.
Application:Part #: 1101030
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: N105001
These are the bolts that hold the engine in.
Application:Part #: 111198005
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 111198001
Engine Gasket Set, 25 HP
Application:Part #: 111101123
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings.
Application:Part #: N0145051
Some of the most common studs you might need.
Application:Part #: 1198035
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:
It's possible to put a generator on an alternator stand but not the other way around.
