Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:This spring returns the clutch arm.
This spring returns the clutch arm. If yours is broken the throw-out bearing will wear out faster. Note: To install this spring first take the clutch cable out of the arm and remove the clip that holds the arm to the shaft. Remove the arm and broken spring. Install the new spring leaving it off the arm. Once the arm is back on with the clip, use a large Phillips screwdriver to pry the hook end of the spring back onto the arm.
No customer reviews for the moment.
Part #: 111141723A
Return Spring For Cross Shaft
Application:Part #: N102401
This is a list of the most common bolts used on a car..
Application:Part #: 1141025CH
HD Pressure Plate 1700 lbs China
Application:Part #: 1141031
These clutch disc do not slip.
Application:Part #: 111721329
Clutch Pedal Shaft Bracket
Application:Part #: 1141024
These are hardend bolts, 10.9 instead of the stock 8.8.
Application:Part #: 111141031E
This disc transfers the power from the motor to the transmission.
Application:Part #: 113721305B
This is the shaft that the clutch pedal attaches to.
Application:Part #: 1141701A
This heavy duty arm is a good idea if you need a new clutch arm.
Application:Part #: 1198026
This kit contains a quality brass bushing, a clutch return spring and retaining clips needed to install the throw-out bearing arm in the transmission.
Application:Part #: 1141027
Kennedy Stage 3 Pressure plate 2600 LB
Application:Part #: 111141031F
This disc transfers the power from the motor to the transmission.
Application:Part #: 1141701B
This heavy duty arm is a good idea if you need a new clutch arm.
Application:Part #: 361141719HD
Clutch Cable Arm Forged for 20mm Cross shaft
Application:Part #: 211141025A
Clutch Cover, 12 volt 200mm, 9 spring
Application:Part #: 1141033
Cushion Clutch Disc - 200mm
Application: