Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:This is the shaft that the clutch pedal attaches to.
This is the shaft that the clutch pedal attaches to. This job is not fun, because you need to remove the pedal assembly, then drive the pin out that holds the clutch pedal to the shaft. Now drive the shaft out of the pedal. Use some white grease on the new shaft and install it in the reverse order. Note: It is a good idea to take the whole pedal assembly apart and regrease all the bushings while you have it out.
No customer reviews for the moment.
Part #: 131141719HDL
Clutch Cable Arm Forged for 16mm Cross shaft
Application:Part #: 311141031B
This disc transfers the power from the motor to the transmission.
Application:Part #: 1141028
Kennedy Stage 4, 3000 LB Pressure Plate
Application:Part #: 111141719HD
Clutch Cable Arm Forged for 20mm Cross shaft
Application:Part #: 311141025E
The clutch cover is also known as a pressure plate.
Application:Part #: 1141701A
This heavy duty arm is a good idea if you need a new clutch arm.
Application:Part #: 111141723A
Return Spring For Cross Shaft
Application:Part #: 1141030
200mm 6 puck Clutch Disc
Application:Part #: 113141701C
This shaft holds the throw-out bearing in place.
Application:Part #: 111141177AS
These clips hold the throw-out bearing to the arm.
Application:Part #: 1141025
Heavy Duty Clutch Pressure Plate - 1700lbs. This is made by KEP
Application:Part #: 111721329
Clutch Pedal Shaft Bracket
Application:Part #: 311141025C
The clutch cover is also known as a pressure plate.
Application:Part #: 1141026
We only offer brand new pressure plates because so-called rebuilt pressure plates never quite come up to factory pressure specs.
Application:Part #: 361141719HD
Clutch Cable Arm Forged for 20mm Cross shaft
Application:Part #: 113141723C
This spring returns the clutch arm.
Application: