Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The clutch cover is also known as a pressure plate. A lot of people replace the clutch cover when it's not necessary. To check the clutch cover, look at the surface where the disc rides, make sure it's in good condition. Now place the clutch cover on the floor and step on it (bounce on it) to see if it still has tension. Note: When putting the clutch cover on, use a clutch alignment tool in the disc and start the bolts by hand. Use wafer washers under the bolts. Tighten the bolts in a star pattern until the cover sits flat. Torque the bolts to 18 ft. lb., any more and they will break, any less and they will come loose.
Bus (Type 2): Diesel Vanagon
No customer reviews for the moment.
Part #: 068141033J
This disc transfers the power from the motor to the transmission.
Application:Part #: 002141701A
This shaft holds the throw-out bearing in place.
Application:Part #: 113141723C
This spring returns the clutch arm.
Application:Part #: N102401
This is a list of the most common bolts used on a car..
Application:Part #: 113141181B
Guide Sleeve
Application:Part #: 1141033
Cushion Clutch Disc - 200mm
Application:Part #: 1198026A
This kit contains a quality urethane bushing, a clutch return spring and retaining clips needed to install the throw-out bearing arm in the transmission.
Application:Part #: 111141165A
Also known as a throw-out bearing, this bearing's function is to disengage the clutch.
Application:Part #: 1198026
This kit contains a quality brass bushing, a clutch return spring and retaining clips needed to install the throw-out bearing arm in the transmission.
Application:Part #: 113198026
This kit contains a bushing, a clutch return spring and the retaining clips to install the throw-out bearing shaft in the transmission.
Application:Part #: 311141031D
This disc transfers the power from the motor to the transmission.
Application:Part #: 251721401A
This master cylinder pushes fluid to the slave cylinder on the clutch..
Application:Part #: 211141031G
This disc transfers the power from the motor to the transmission.
Application:Part #: 002141701
This shaft holds the throw-out bearing in place.
Application:Part #: 311141025C
The clutch cover is also known as a pressure plate.
Application:Part #: 131141719HDL
Clutch Cable Arm Forged for 16mm Cross shaft
Application:
