Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The sending unit registers the fuel level on the gauge.
The sending unit registers the fuel level on the gauge. There were two types, mechanical for Bugs up to 1967 and electrical for Bugs 1968 and on. There is no such thing as 6v or 12v electrical sending units, as they have a floating ground. Before replacing the electrical unit, take the wire off of it and hold it to ground (a bolt or metal on the body). CAUTION: WHENEVER WORKING AROUND LIVE WIRES AND GAS BE VERY, VERY CAREFUL. Turn the key on. If the gauge goes to full, the sending unit is bad. If it doesn't, the gauge and or the vibrator is bad.
Bus (Type 2): 73-79
No customer reviews for the moment.
Part #: 111209147A
This tube like screen is located in the bottom of the gas tank.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 311971907
Turn Signal Switch Grommet for Type 1, fuel pump and backup harness grommet on late Type 2, and main harness through body early Type 2
Application:Part #: 211209021D
This pipe comes out of the bottom of your gas tank.
Application:Part #: 211201521A
Truck Hard Fuel line Tank to Motor
Application:Part #: 251919051E
The sending unit registers the fuel level on the gauge.
Application:Part #: 261827600
Gas Door Hardware Kit
Application:Part #: 211201125
Fuel Tank Filler Hose
Application:Part #: 211201075M
Fuel Tank. This tank can be used with non fuel injected busses, you just need to plug the injection return line.
Application:Part #: 113919133
The sending unit registers the fuel level on the gauge.
Application:Part #: 261829661
Gas Door Lock Seal
Application:Part #: 133133511
This filter goes in line with the fuel line, keeping dirt or rust out of the carburetor.
Application:Part #: N203631
Vent Hose, Filler to T, 14mm x 215mm
Application:Part #: 343201551C
Locking Gas Cap
Application:
The sending unit registers the fuel level on the gauge.
