Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The sending unit registers the fuel level on the gauge. 7 1/2" long
The sending unit registers the fuel level on the gauge. There were two types, mechanical for Bugs up to 1967 and electrical for Bugs 1968 and on. There is no such thing as 6v or 12v electrical sending units, as they have a floating ground. Before replacing the electrical unit, take the wire off of it and hold it to ground (a bolt or metal on the body). CAUTION: WHENEVER WORKING AROUND LIVE WIRES AND GAS BE VERY, VERY CAREFUL. Turn the key on. If the gauge goes to full, the sending unit is bad. If it doesn't, the gauge and or the vibrator is bad.
No customer reviews for the moment.
Part #: 251919051E
The sending unit registers the fuel level on the gauge.
Application:Part #: 211201255
This collar goes around the gas tank neck on buses 1955-1967.
Application:Part #: 261829661
Gas Door Lock Seal
Application:Part #: 111201551AL
Locking Gas Cap
Application:Part #: 311971907
Turn Signal Switch Grommet for Type 1, fuel pump and backup harness grommet on late Type 2, and main harness through body early Type 2
Application:Part #: N203631
Vent Hose, Filler to T, 14mm x 215mm
Application:Part #: 211201075L
Fuel Tank For Carbureted Applications only. At this point in time we can not get this tank and we are using the 211201075M fuel injection take and just plugging off the return line.
Application:Part #: 261201651
Fuel Tank Mounting Strap, Set of 2
Application:Part #: N203761
Tank Breather Hose 10mm ID, per foot
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 111209113A
Fuel Tap Rebuild Kit
Application:Part #: 211201105
Fuel Sender Blockoff Plate
Application:Part #: 211201055B
These are new Brazilian tanks.
Application:Part #: 211201551GR
The most common reason, for replacing a cap is forgetting to put it back on at the gas station.
Application:
The sending unit registers the fuel level on the gauge. 7 1/2" long