Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are new Brazilian tanks.
These are new Brazilian tanks. There are four 13mm headed bolts holding it. Make sure you are using German fuel line when putting it back in. The 61-67 tanks take a different cap, which is the same as a 68- one. Caps are separate. For Buses, you will need to have the motor out. Trucks, the tank is in the bed. It is a good idea to buy a neck collar when replacing a tank. NOTE: Disconnect the battery when replacing the tank.
Bug (Type 1): 61-67
Ghia: 61-67
Race/Off-Road: 61-67
No customer reviews for the moment.
Part #: 111209175B
Grommet for Reserve Lever
Application:Part #: 141201122
Gas Tank Breather Tube Sleeve
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 113201075AB
These are new Brazilian tanks.
Application:Part #: 133201181A
Fuel Elbow, "T" to Main Exit
Application:Part #: 113919049D
The sending unit registers the fuel level on the gauge.
Application:Part #: 133133511
This filter goes in line with the fuel line, keeping dirt or rust out of the carburetor.
Application:Part #: 113201621
This is the packing that goes around the gas tank opening, sealing off air and dirt from entering the trunk.
Application:Part #: 321201551H
The most common reason, for replacing a cap is forgetting to put it back on at the gas station.
Application:Part #: 803201511E
This filter goes in line with the fuel line, keeping dirt or rust out of the carburetor.
Application:Part #: 111919051
Fuel Tank Sending Unit
Application:Part #: 111201557B
Gas Cap Gasket, 100mm
Application:Part #: 211201557A
Cork Gas Cap Gasket, fits 60mm fuel caps
Application:Part #: 113201215
This is a small rubber sleeve that goes on the neck of the gas tank before you slide the fuel filler hose on..
Application:
These are new Brazilian tanks.