Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:
This hose goes from the filler neck to the tank.
This hose goes from the filler neck to the tank. This hose is for the tanks that had a metal elbow in the middle of the line, so two pieces are usually needed.
Bug (Type 1): 69-
Race/Off-Road: 69-
No customer reviews for the moment.
Part #: 111209147A
This tube like screen is located in the bottom of the gas tank.
Application:Part #: 111201557B
Gas Cap Gasket, 100mm
Application:Part #: 111209021F
This pipe comes out of the bottom of your gas tank.
Application:Part #: 343201551C
Locking Gas Cap
Application:Part #: 131201127
This is a rubber flap that folds out protecting the side of the car when filling it with gas.
Application:Part #: 111201261
Fuel Breather Hose Clip
Application:Part #: 321201551H
The most common reason, for replacing a cap is forgetting to put it back on at the gas station.
Application:Part #: N203631
Vent Hose, Filler to T, 14mm x 215mm
Application:Part #: 113201157
Fuel Breather "T"
Application:Part #: 113919049C
The sending unit registers the fuel level on the gauge.
Application:Part #: 111809905D
Fuel Filler Door
Application:Part #: 113201621
This is the packing that goes around the gas tank opening, sealing off air and dirt from entering the trunk.
Application:Part #: 111209113A
Fuel Tap Rebuild Kit
Application:Part #: 133133511
This filter goes in line with the fuel line, keeping dirt or rust out of the carburetor.
Application:Part #: 141201122
Gas Tank Breather Tube Sleeve
Application:
This hose goes from the filler neck to the tank.
