Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:Heater cables open the flaps in the heater boxes allowing heat into the car.
Heater cables open the flaps in the heater boxes allowing heat into the car. When you install the cables use white grease. Place the control(s) in the off position and crawl under the Bug and hook up the heater boxes. (A buddy sure would be helpful.) Now get back up and put the control(s) in the full on position and then crawl back under the car and push the lever on the heater box all of the way forward and lock into place. (Remember exercise is good for you.) Now recheck the levers to make sure they are closed when the control(s) are in the off position. On 1964 and earlier Bugs, the heater cable is attached to a slide. To get the slide out, twist the knob clockwise all the way. Just under the knob you will see a knurled collar. Wrap a rag around this collar and use a pair of pliers to unthread it. Once the collar is unthreaded you will be able to pull the slide out. When putting the slide back in make sure that the slot in the slide indexes itself to the spot on the slide hole.
No customer reviews for the moment.
Part #: 111711717A
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 111711611BK
This knob fits on the heater control.
Application:Part #: 111711713A
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 111711611GY
This knob fits on the heater control.
Application:Part #: 111711629E
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 111129921
This is the barrel lock that locks the cable to the carb. It is also used on the Heater Cables
Application:Part #: 133819791
footwell cable
Application:Part #: 111711691
These little boots fit on the end of the heater tubes where the cables run through.
Application:Part #: 111711713
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 111711629B
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 111711611IV
This knob fits on the heater control.
Application: