Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This seal goes between the handle and the body.
This seal goes between the handle and the body. The door handle must be romoved to replace them.
Bug (Type 1): 60-65
Race/Off-Road: 60-65
No customer reviews for the moment.
Part #: 113611301H
Brake Fluid Reservoir, 1967 Only
Application:Part #: 211405375
These joints are located in the ends of the control arms.
Application:Part #: 1601063CH
Empi 4 Spoke, Chrome, 4x130, 15x5.5"
Application:Part #: 113611764B
These are the metal brake lines found throughout the car.
Application:Part #: 141201122
Gas Tank Breather Tube Sleeve
Application:Part #: JC22380
Jaycee Fuel Pump Block off w/ AN 8 Fitting, Black
Application:Part #: 135998162
The wiper arms are connected to these shafts.
Application:Part #: 133863507D
Front Trunk Liner Upper
Application:Part #: JC23180
Jaycee Tapered Ring Compressor 96.9mm
Application:Part #: 111953549
Grommet for Headlight Harness thru Trunk
Application:Part #: 1129627
CB 650 Dual Valve Springs (Set)
Application:Part #: 155885665
These are the parts needed to hold the back of the rear seat up.
Application:Part #: 1615112
Rear Disc Brake Kit With E-Brake, 5x130 w/ 14x1.5mm threads or 5x4.75" w/ 12mm threads, IRS
Application:Part #: 1117698
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:Part #: 6411106
Thru Rod, Stock Width Beam, 40.5" Long, Boxed
Application:Part #: 113847080
Pop Out Window Latch, White, Right
Application:
This seal goes between the handle and the body.