Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These push rods are made out of chromoly steel and do not expand at the same rate as aluminum.
These push rods are made out of chromoly steel and do not expand at the same rate as aluminum. With these, you have to set your valves at .003" so they don't rattle as the motor gets warm. We do not recommend steel push rods unless you are running a large cam and dual valve springs, at which point, your car is now more of a toy then a reliable daily driver. At .003" clearance you will need to adjust your valves frequently. The rods come uncut, so you'll need a lathe to cut them or you can call us with the measurements and we'll cut them for you. You must set up your rocker geometry first, as this determines the length. If you don't know how do this. If you don't know how to do this, call us and we will talk you through it.
Bug (Type 1): 1600
Type 3: 1600
Ghia: 1600
Thing: 1600
Race/Off-Road: 1600
No customer reviews for the moment.
Part #: 111198541GR
The cam rides in these bearings.
Application:Part #: 1109613
Stainless steel valves are used in the big valve heads.
Application:Part #: 311109601
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:Part #: 043109611A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109337
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 111109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 1109002
Premium Performance Aftermarket Cam Gear
Application:Part #: 1109460
These shims are used under the rockers to set the geometry.
Application:Part #: 1109451
This style of adjusting screw has a ball with a flat side on the end.
Application:Part #: 1109335
These stock-style tubes are made of stainless steel.
Application:Part #: 113109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 113109345A
These are the seals that go around the push rod tubes.
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:Part #: 1109338
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 111109301A
These rods link the cam to the valves.
Application:Part #: 11094011
Rocker Arms Kit, HP Stock 1.1
Application:
These push rods are made out of chromoly steel and do not expand at the same rate as aluminum.
