Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Rings on the pistons are there to eliminate "blow-by".
Rings on the pistons are there to eliminate "blow-by". To see if your cylinders or rings are worn out, take a top ring and place it into the cylinder about an inch down from the top. Using a piston with no rings, push the ring down making sure it is sitting flat in the cylinder. With the ring in the cylinder, use a feeler gauge to measure the ring gap. If it is over .030", either the ring or the cylinder is worn out. If you feel a ridge on the top of the cylinder, then it's a bad cylinder and time for a new set of pistons and cylinders. We prefer using cast rings instead of chrome rings. Chrome rings never seem to seat. This causes a lot of "blow-by". Note: Use ring spreader pliers to put the rings on. When putting the cylinders on, make sure none of the ring gaps are lined up.
Bus (Type 2): 1800
No customer reviews for the moment.
Part #: 1101355
Here's another long subject, but it'll give you a little something to think about.
Application:Part #: 1198161A
These rings are cast iron.
Application:Part #: 1101484
This is like a stock gasket except it is made out of rubber instead of cork.
Application:Part #: 2101306
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101346
36 HP Barrel Shims .060 (4)
Application:Part #: 021101487
Valve Cover Retaining Clip
Application:Part #: 111198057
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 2101302
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 029198075CH
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 021198075BCH
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1198090BCH
90.5mm Pistons & Cylinders - 82mm Stroke CHINA
Application:Part #: 1101477BL
These covers look good but have a tendency to leak.
Application:Part #: 1101394
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 111198057A
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 022198075ACH
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1198090B
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:
Rings on the pistons are there to eliminate "blow-by".
