Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
These locks keep the vent wing closed, therefore a must, but they're a pain to replace. Start by removing the glass and rubber. Use a 1/8" drill and drill out the original rivets. Next, remove whatever is left of the old lock and install the new lock. Using 1/8" pop rivets, install the head of the lock from the frame side. With a hammer and dolly, very carefully flatten what's left of the rivet on the latch side. Now replace the glass and rubber.
Bug (Type 1): 65-67
Type 3: 62-67
Race/Off-Road: 65-67
No customer reviews for the moment.
Part #: 251957809K
Upper Speedometer Cable, 1410mm (55.51")
Application:Part #: 1845111AL
Bug Safari Glass to Frame Seal
Application:Part #: 113853505F
This is the front strip that goes down the front hood.
Application:Part #: 311881403
Like the door panels, seat covers are a long subject; so here's the basics
Application:Part #: 112863404
These carpet kits are to be used with the original rubber floor mats.
Application:Part #: 1117113
This adapter replaces the stock oil cooler with two hoses to reroute the oil to an external oil cooler.
Application:Part #: 111701061N
Left hand Floor Plan for Type 1 1971-72
Application:Part #: 03214
These are the parts found in the distributor.
Application:Part #: 6513031
These mounts are made to get more than one shock on the back or your car.
Application:Part #: 6115454
Billet Aluminum Knock-Off Oil Cap with Vent, Set
Application:Part #: 6707304
These bumpers are made for Baja Bugs.
Application:Part #: 1119528CH
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 111401315
Torsion Arm Bushing, 8 Per Car
Application:Part #: 111101481
This gasket goes between the valve cover and the head.
Application:Part #: 113415813D
These are the ball joints on the tie rods.
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
