Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
These locks keep the vent wing closed, therefore a must, but they're a pain to replace. Start by removing the glass and rubber. Use a 1/8" drill and drill out the original rivets. Next, remove whatever is left of the old lock and install the new lock. Using 1/8" pop rivets, install the head of the lock from the frame side. With a hammer and dolly, very carefully flatten what's left of the rivet on the latch side. Now replace the glass and rubber.
Bug (Type 1): right,56-64, Conv.,56-64
Race/Off-Road: right,56-64
No customer reviews for the moment.
Part #: 1711110NSP
Night Stick Pro
Application:Part #: 151837572D
Front Window Sash, Right, Convertible Only
Application:Part #: 1109641
If you are going to run dual springs we suggest you use these valve spring retainers as well.
Application:Part #: 211813356IX
This is a repair panel for the rear corner.
Application:Part #: 1127022RD
Billet Fuel Pump Block off, Red
Application:Part #: 211611723A
These are the metal brake lines found throughout the car.
Application:Part #: 1101353
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 6501149108BO
Overboot Only for 930 CV, Each Offroad applications
Application:Part #: 111127531
8mm Fuel Line Ferrule
Application:Part #: 111823731
This is the seal that goes on the body for the front hood to sit on.
Application:Part #: 6615104A
Front Rotor for Disc brake setup, 5/205 bolt pattern, 12x1.5mm threads -1965
Application:Part #: 113129415B
Here are some of the replacement parts for your stock carburetor. Sold individually.
Application:Part #: 1615100B
This kit allows you to bolt disc brakes onto your Bug king and link pin or ball joint front end.
Application:Part #: 113501305
Inner Wheel Bearing Spacer
Application:Part #: 1615126A
Brake line adapter for Calipers (1615125A and 1615124A) Female ID 10mx1.00/ Male OD 10mx1.50
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
