Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:Kits contain the pins, bearings and shims which attach the spindle on king and link front ends to the axle beam.
Kits contain the pins, bearings and shims which attach the spindle on king and link front ends to the axle beam. They allow the spindle to move up and down. The only way you can check yours is to tear them out of the spindle. Once you have them out look for pits in the pin, outer race and bearing. Count your shims and make sure you have 8 per pin. The reason you don't see 1963 listed is on a 63 it is one or the other. 1955-1962 is a 20mm pin and 1964-1967 is a 22mm pin. You will also see here good used parts as well.
No customer reviews for the moment.
Part #: 113105245FS
This seal goes behind the flywheel.
Application:Part #: 211843751
Sliding Door Rubber Stop
Application:Bus (Type 2); 68-79
Part #: N120141
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 151871100B
Convertible Top Frame Butt Plates
Application:Part #: 1105401CB
H-Beam Rods 5.500" Chevy Journal set of 4
Application:Part #: 261801477
Single Cab Pickup Rear Bed Section 61"x36"
Application:Part #: T1129028
Some carb combo's are tricky to sync, like kadrons that have a stud sticking up.
Application:Part #: 1823565
This guard goes underneath the front hood handle to prevent your fingernails from scratching the paint..
Application:Part #: 343853343
Seal between Roof and Molding
Application:Part #: 141707138D
Front Bumper Bracket Seal Right
Application:KG: 72-74
Part #: 144867501
This is the vinyl covering for the inside roof and sides of the Ghia.
Application:Part #: 6823565
There are two types of hold downs, rubber and steel.
Application:Part #: 2129040E
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 311141031B
This disc transfers the power from the motor to the transmission.
Application:Part #: 1107431
There are two types of keepers we like to use.
Application:Part #: N140011
Screw for Assist Strap
Application: