Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Most people don't realize that these are one of the most important parts in the motor.
Most people don't realize that these are one of the most important parts in the motor. When a rod is reconditioned the cap is separated, the bolts taken out and the cap mating surfaces ground. The rod is then put back together now having an oval hole. This hole is then machined round again. The problems we have seen are; the boring of the hole and bushing being bored crooked, throwing the rod side ways when the cylinder fires. The other problem is that, if one rod has been reconditioned once and the others five times then one rod is a lot longer than the others, affecting the compression ratio. You might have compression ratios of 7.7 in 3 cylinders and 9.1 in one cylinder; the result is an unbalanced engine and major detonation in one cylinder. The rods we carry are checked for straightness, and weighed to within 10 grams and matched for length to .005. All rods are sold in sets on an exchange basis.
Bug (Type 1): 36HP
Bus (Type 2): 36hp
Ghia: 36hp
No customer reviews for the moment.
Part #: 211498211BCO
CORE CHARGE If you would like to order these before sending your old spindles in, please add part this to your order. This is the core charge. Once you send back your old spindles we will refund that amount, providing your spindles are good.
Application:Part #: 4881216
We really like the style and comfort that these seats provide.
Application:Part #: 211703120AX
This is where you would put in the stock jack to jack up the bus.
Application:Part #: F1129032
These are the glues and oils we use..
Application:Part #: 1511220
Torsion Tube End Plates, Outer, Pair
Application:Part #: 111837000
Vent Wing Window Installation Kit
Application:Part #: 111837657A
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
Application:Part #: 311115541
This boot goes on the end of the dump tube.
Application:Part #: 1415609BK
Banjo Style Vintage Steering Wheel Kit, Black
Application:Part #: 111405692
Bearing grease Cap no hole
Application:Part #: 1611750A
These stainless steel braided flex lines don't swell like the original rubber hoses and they make the undercarriage look a lot nicer.
Application:Part #: 1817022HD
This is a cover that goes over the whole car.
Application:Part #: 113867549C
VW Headliner Bow, 4 feet, Each
Application:Part #: 211615107CO
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle.
Application:Part #: 1707135ABK
This is one of the original bumper options that was used on the first Cal-Look Bugs back in the 70's.
Application:Part #: 1129517
Linkage Ball End Bushings, Pair
Application:
Most people don't realize that these are one of the most important parts in the motor.