Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This lever is found in the glove box.
This lever is found in the glove box. It is used to release the front hood. It was riveted to the glove box from the factory. To replace, you will need to drill out the three rivets. We suggest you use some nuts and bolts instead of rivets to put it back in.
Bug (Type 1): 68-77
Type 3: 68-74
Off-Road: 68-77
No customer reviews for the moment.
Part #: 2251006CC
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: N120801
These are four little plastic pieces that push into the front hood to hold the emblem in place.
Application:Part #: 211845225B
Sliding Door Glass with hole, fits either side
Application:Part #: 1601059CCP
Empi Raider Chrome Replacement Center Cap
Application:Part #: 1105723
Chevy Rod Bearings .030
Application:Part #: 251957809B
This cable goes from the speedo to the driver side front wheel.
Application:Part #: 251837206
These are the front door handles.
Application:Part #: 111957397
This holds the dash lights into the speedo head.
Application:Part #: 211511245
This rubber "donut" goes around the spring plate, allowing it to move up and down.
Application:Part #: 1863620BS
Center Console Basket (Small)
Application:Part #: 411941189
Grommet, Headlight Wire to Bucket
Application:Part #: 111837565A
Lift channel Weatherstrip
Application:Part #: F1612
These are the glues and oils we use..
Application:Part #: 131611055GR
This hydraulic slave cylinder is found in the rear brake backing plate.
Application:Part #: 311198573RK
This kit comes with the gaskets, the needle and seat, and accelerator pump diaphragm for the carburetor..
Application:
This lever is found in the glove box.