Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
There are two types of sand seals. One type just bolts in, but the other style requires the case to be machined. We've had poor luck with the bolt-in style, so we machine our cases. A couple of tricks here. After you have installed the seal (machined-in) spread a thin layer of JB Weld on the seal surface to the case. This trick will keep the seal from spinning. The other trick is if you're using an aluminum pulley, be sure you machine it down and use a steel sleeve on it. If you don't, the seal will quickly wear a groove in the pulley.
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: N110104
Some of the more common nuts you might need..
Application:Part #: 1101113KT
This kit has all the oil galley plugs in it.
Application:Part #: 6105247
There are two types of sand seals.
Application:Part #: 1101211
This chrome stand dresses up your engine.
Application:Part #: 111198007AF
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 1101025
Mag Case bored to 90.5
Application:Part #: 111199101
These are the bolts that hold the engine in.
Application:Part #: 1101461KIT
This kit has the correct studs for a dual port engine to hold the heads on. 10mm
Application:Part #: 1101031
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: N115244
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 1101146
These cheater studs replace the head studs that have pulled from the case.
Application:Part #: 1101026AL94
Aluminum "Super Case" for 94mm Bore
Application:Part #: 113105245FRS
Rear Main Seal, Double Lipped
Application:Part #: 113101211G
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: N110085
Some of the more common nuts you might need..
Application:
