Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The front door window rolls up and down between these two rubber seals.
The front door window rolls up and down between these two rubber seals. The outer scraper is very important because it keeps water out of the door, it's also the "most fun" to put in. No kidding; installing these seals are a real chore. Start by gutting the door. When installing these seals, check the little drain holes in the bottom of the door to make sure they're clear. Note: We found the old clips that hold the scrapers in are much better then the new clips they come with.
Bug (Type 1): 52-64
Off-Road: 52-64
No customer reviews for the moment.
Part #: 111823731
This is the seal that goes on the body for the front hood to sit on.
Application:Part #: 620107208SS
Replacement Stainless Steel Fuel Tank Brackets 8" Diameter
Application:Part #: 113119031A
This is the fan that fits inside of the fan shroud on Bugs 1971-1979 and a 1971 Bus.
Application:Part #: 1129040E
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 2711102
The aftermarket shifters listed here, shorten the shift pattern considerably.
Application:Part #: n122951
Reduction Box, Locking Ring, 1 per side
Application:Part #: VDO153002
These mini gauges are made to screw right into a 1/8" NPT connection.
Application:Part #: 1251008H
1 5/8" Merged Flanged Header with Stinger (No Heater Boxes Included)
Application:Part #: 1601119
These protect your mags from theft.
Application:Part #: 1129729RD
These boots are better than stock.
Application:Part #: 113827571B
This is the rear handle that opens the engine lid.
Application:Part #: 171867500
This is the vinyl covering for the inside roof and sides of the Bug.
Application:Part #: 043133241
These two boots connect the intake manifold with the end casting on a stock dual port 1600cc engine.
Application:Part #: 1117103ALF
# 8 Hose End 120 degree
Application:Part #: 113501831
Long Z-Bar Plastic Sleeve, Each
Application:Part #: 251819019
Dash Defroster/Heater Blower Fan/Motor
Application:
The front door window rolls up and down between these two rubber seals.
