Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the seal that goes on the body for the front hood to sit on.
This is the seal that goes on the body for the front hood to sit on. It seals the trunk compartment. Removing the old seal is just a matter of ripping it out. Before you try and put the new seal in, take some time and straighten out the groove it goes in. To put the seal in, start on one side in an upper corner, use some dish soap on the seal and slide it from one side to the other corner then down both sides. On Bugs 1961 on, stick the little nubs in the corner through the holes and use a pair of needle nose pliers to pull the nubs all the way through. On Super Beetles they have pins that hold the seal in the corners. Don't stretch the rubber, as overtime it will shrink.
Bug (Type 1): SB,73-79
No customer reviews for the moment.
Part #: 2501603
We make wheel adapters for some of the more common drums and wheels.
Application:Part #: 111885403
Like the door panels, seat covers are a long subject; so here's the basics.
Application:Part #: 313877407
These are all of the parts that we can get our hands on for metal sunroof bugs.
Application:Part #: 111405691B
This is the cap that goes on the outside of the drum; covering up your bearing.
Application:Part #: 113711341
Emergency Brake Handle Retaining Pin
Application:Part #: 111945117A
This seal goes between the tail light housing and the body of the car..
Application:Part #: 1105401CB
H-Beam Rods 5.500" Chevy Journal set of 4
Application:Part #: 143845521AAM
Rear Window Seal With Chrome Molding Groove
Application:KG; 56-66
Part #: 1129804
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 211841821
Seals the side cargo doors on buses up to 1967.
Application:Part #: 133201181A
Fuel Elbow, "T" to Main Exit
Application:Part #: 6845112
Replacement Seal for Windshield, 10 ft roll
Application:Part #: 251698003
This kit has all the springs, pins and keepers for drum brakes.
Application:Part #: 151845521DCL
This seal is for the rear window. This is for a CONVERTIBLE ONLY.
Application:Part #: 111827517
This is the seal that goes under the deck lid handle..
Application:
This is the seal that goes on the body for the front hood to sit on.