Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the front drums that the brake shoes ride on.
These are the front drums that the brake shoes ride on. Note: Don't over tighten the bearing nut, just snug it down against the bearing thrust washer. Now line up the handle of your wrench with one of the five lug nut holes and back the nut off so that the handle of the wrench lines up with the next hole. If your drums are four lug, then back the nut off just before the next hole. You do this to prevent the bearings from heating up and wearing away.
No customer reviews for the moment.
Part #: 211609209
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 113609205A
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 131609209
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 211611477A
This valve in the wheel cylinder allows you to bleed the brakes.
Application:Part #: 211611483
This valve in the wheel cylinder allows you to bleed the brakes.
Application:Part #: 113698293
This kit is for rebuilding the front wheel cylinder.
Application:Part #: 113611057B
This hydraulic slave cylinder is found in the front brake backing plate.
Application:Part #: 113698002
This kit has all the springs, pins and keepers for drum brakes.
Application:Part #: 111698002
This kit has all the springs, pins and keepers for drum brakes.
Application:Part #: 113609237D
These four shoes or linings are in the front drums and are sold on an exchange basis.
Application:Part #: 113501835
Z-Bar Damping Ring, Operating Rod, Each
Application:Part #: 113721163
This spring returns the brake pedal, it is very important.
Application:Part #: 311698151C
Front Brake pad set
Application:Part #: 1119302BK
These cylinder head tins sit under the fan shroud.
Application:Part #: 211837639A
Vent Window Latch Plate, Black knob and base, chrome button as original, Left
Application:Part #: 211881865A
Rubber stops that the front seats rest on.
Application:Part #: 211837375B
Front Door Felt Channel Kit (No Notch)
Application:Part #: 251615124C
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle.
Application:Part #: 211703134
Outrigger, Right Rear
Application:Part #: 1105258
This is a stock, zinc-plated crankshaft pulley bolt that has a 3/8" drive hole broached into the center.
Application:Part #: 211209021A
Fuel Tap, with removable base
Application:Part #: T1101211INT
This 1/2" drive tool takes off the oil filler.
Application:Part #: 211857501H
Interior Rear View Mirror
Application:Part #: 1198036
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:Part #: 113805135
Strut Tower Repair Section, Left, Super Beetle Only
Application:Part #: 2129040E
We've found that dual carbs work better than any single carburator set up.
Application:
These are the front drums that the brake shoes ride on.
