Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the plate on the bottom of the motor.
This is the plate on the bottom of the motor. To install one on a 40hp-1600cc motor, proceed in this order: Gasket against the case, the screen, another gasket, and then the plate. Now put the copper washers on the studs and then the six cap nuts. Be sure to use Gasgacinch on the gaskets and do not over tighten the nuts. We highly recommend you use cap nuts on the studs. Note: Make sure the drain plug in the middle, is in tight.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Type 3: 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: N110085
Some of the more common nuts you might need..
Application:Part #: JC22970
Jaycee Billet Full Flow Pump Cover w/ -8 O-ring Fitting, Red
Application:Part #: 1115449BL
Replacement Oil Cap Billet Blue
Application:Part #: 1115450PL
The oil filler extension screws into the generator stand and comes with a fitting to vent the crankcase.
Application:Part #: JC22270
Jaycee Billet Oil Cap with Breater -10 AN Fitting, Blue
Application:Part #: 1115107AFF
26mm Oil pump for dual relief case with a flat cam. For full flowed motors only.
Application:Part #: 1115141
This oil pump cover comes with a threaded boss.
Application:Part #: 1117109
This block off plate is made to loop the oil back into the case in place of the stock oil cooler.
Application:Part #: 1117698
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:Part #: 1115449BK
Replacement Oil Cap Billet Black
Application:Part #: 1117110
This adapter replaces the stock oil cooler with two hoses to reroute the oil to an external oil cooler.
Application:Part #: 1115467
This is a breather box that will give excess "blow by" a place to go.
Application:Part #: 1115467HO
This is a breather box that will give excess "blow by" a place to go.
Application:Part #: 1115183BL
This plate is made out of a solid piece of aluminum. Blue
Application:Part #: 111115107AK
VW flat cam, 21mm, 8mm Stud Oil Pump
Application:Part #: 1117022
Mesa coolers are the state of the art oil coolers.
Application:
This is the plate on the bottom of the motor.