Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The rear wheel attaches to the rear brake drum.
The rear wheel attaches to the rear brake drum. Make sure you torque the axle nut to 250 ft. lb., we don't want any wheels falling off. We suggest you drive the Bug for a day and tighten the nut again. For some reason the nut seems to loosen up the first time. Always use a cotter pin to lock the nut. If the hole doesn't line up, tighten it a little bit more until it does. Never, ever back the nut off to line up the hole.
No customer reviews for the moment.
Part #: 113609205A
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 131609209
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 211611477A
This valve in the wheel cylinder allows you to bleed the brakes.
Application:Part #: 211611483
This valve in the wheel cylinder allows you to bleed the brakes.
Application:Part #: 311611067C
This hydraulic slave cylinder is found in the rear brake backing plate.
Application:Part #: 311698003
This kit has all the springs, pins and keepers for drum brakes.
Application:Part #: 311609537E
These shoes or linings are in the rear drums and are new, so no exchange.
Application:Part #: 113609237D
These four shoes or linings are in the front drums and are sold on an exchange basis.
Application:Part #: 1903109BL
Billet Alt/Gen Pulley Blue
Application:Part #: 151871199A
This is the pad between the top material and the headliner.
Application:Part #: 111837421
Clip, holds rear metal felt run channel in place (2 required per car)
Application:Part #: 113863711
This is a full carpet kit.
Application:Part #: 01006
These are the parts found in the distributor.
Application:Part #: 151871341
These strips screw to the top.
Application:Part #: 133701571
Front inspection seal
Application:Part #: 151863403
This is a full carpet kit.
Application:Part #: 211945363A
This is the lens that you see on the side of the bus in the front and the rear.
Application:Part #: 111953041MT
Weld on Mount for Bullet Turn Signal Assembly
Application:Part #: 221847219
This triangular plate is welded to your bus to allow you to screw in your pop-out window latch.
Application:Part #: 111821532A
Running Board Material, Right
Application:Part #: 113819532
This is an aluminum trim piece that clips over the lip of the defroster vents at the corners..
Application:Part #: 251609615
The rear wheel attaches to the rear brake drum.
Application:Part #: 153863403
This is a full carpet kit.
Application:Part #: 211405129
These seals go around the arms to keep the dirt out of the front beam.
Application:
The rear wheel attaches to the rear brake drum.
