Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The oil pump is the heart of the engine, so it is very important to choose the right one.
The oil pump is the heart of the engine, so it is very important to choose the right one. When ordering a pump you will need to know if your case is a single or dual relief, if you have a dished or a flat cam and if you want a standard or heavy duty pump. Remember that you can only pump so much oil through a certain size hole, so be careful in ordering a heavy duty pump. We feel that any pump with gears larger than 30mm is a waste of money. Note: When replacing a pump make sure you use four new sealing nuts.
Bug (Type 1): 72-79
Vanagon: 83-91
Type 3: 72-73
Ghia: 72-74
Thing: 73-74
No customer reviews for the moment.
Part #: N110623
Some of the more common nuts you might need..
Application:Part #: 1115457BK
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily. Black
Application:Part #: 1117699
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:Part #: 111115111A
The oil pump is the heart of the engine, so it is very important to choose the right one.
Application:Part #: 1115120
Melling Oil Pump for 8mm Studs with Flat Cam Gear
Application:Part #: 1117100
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 1115453
This stock oil filler and cap has been chromed.
Application:Part #: 311115541
This boot goes on the end of the dump tube.
Application:Part #: 1115107FF
30mm Oil pump for Dual Relief & Flat cam Full Flowed Engines
Application:Part #: 2117004
This adapter is used to mount an oil filter either by itself or in line with an oil cooler.
Application:Part #: 111115111B
The oil pump is the heart of the engine, so it is very important to choose the right one.
Application:Part #: 1115109
This oil thermostat goes in line on your external oil cooler system.
Application:Part #: 1115456
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily.
Application:Part #: 111117021ERB
This stock oil cooler cools the hot oil coming from the engine.
Application:Part #: N110062
Some of the more common nuts you might need..
Application:Part #: 1117698
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:
The oil pump is the heart of the engine, so it is very important to choose the right one.
