Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The striker is what keeps the door closed, an absolute necessary part to say the least.
The striker is what keeps the door closed, an absolute necessary part to say the least. They are held in place by large screws. We suggest you use an impact drive to get the striker out. Note: Use masking tape to mark two sides of the old striker, so you will know where to set the new one. Before you completely tighten down the new striker, close the door and see how it lines up. If it lines up, tighten the screws. If it doesn't, start making adjustments until it does.
Bug (Type 1): 67-79
Race/Off-Road: 67-79
No customer reviews for the moment.
Part #: 311698151C
Front Brake pad set
Application:Part #: NGK D9EA
This Spark plug is only used for Racing or Competition vehicles due to the size of the Spark Plug; Dimensions Below Thread Pitch: 12mm x 1.25mm, Thread Length: 19mm (3/4") Verify that the Thread Pitch and length is compatible with your heads if you have any questions call and ask prior to ordering.
Application:Part #: 1107434
Not our favorite type of piston pin keeps.
Application:Part #: 151885371
This is the padding that sits on top of the springs of the seat.
Application:Part #: 113517289A
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 113707233WW
Bumper Support
Application:Part #: 113853505K
This is the front strip that goes down the front hood.
Application:Part #: 1101484
This is like a stock gasket except it is made out of rubber instead of cork.
Application:Part #: 211405615CGR
These are the front drums that the brake shoes ride on.
Application:Part #: 6513401
This boss comes in real handy when making upper shock mounts or putting on rear lower shock mounts in IRS cars..
Application:Part #: 211843710
Sliding Door Lock Cylinder With Key
Application:Bus (Type 2); T2 76-79
Part #: 112950502IDA
Stack Hold Down Screw and Washer
Application:Part #: 068141025D
The clutch cover is also known as a pressure plate.
Application:Part #: 211881715
These are covers for the seat headrests.
Application:Part #: 6012903
This pole has a light on the top of it, just above the flag.
Application:Part #: 211801051JR
This area tends to rust.
Application:
The striker is what keeps the door closed, an absolute necessary part to say the least.