Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the front brake rotor that the pads ride against on the disc brake front ends.
This is the front brake rotor that the pads ride against on the disc brake front ends. Note: When tightening the bearing nut, snug it down against the bearing thrust washer. Now line up the handle of your wrench with one of the lug bolts and back the nut off so the handle of the wrench lines up with the next bolt (a fifth of a turn). Those useing four lug rotors back off just before the next lug bolt. This will prevent bearings from heating up and wearing out.
No customer reviews for the moment.
Part #: 211615107A
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle. If you are ordering this without sending your core in first you will need to order the core as well. The core charge will be refunded when we get your core back and it is rebuildable.
Application:Part #: 211615108A
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle. If you are ordering this without sending your core in first you will need to order the core as well. The core charge will be refunded when we get your core back and it is rebuildable.
Application:Part #: 1129708
This pair of aluminum end castings are for use with a center section manifold.
Application:Part #: 021105701ABR
These are the shells that go in the rods and ride on the crank.
Application:Part #: 111819945
Heater Hose to Body Seal
Application:Part #: 021198573
This kit comes with the gaskets, the needle and seat, and accelerator pump diaphragm for the carburetor..
Application:Part #: 211711195
Shift Rod Guide Tube
Application:Part #: 151863703
This is a full carpet kit.
Application:Part #: 265809041A
Side Panel, Crew Cab Only, Left
Application:Part #: 211813227
This is a repair panel for the area above the engine lid.
Application:Part #: 111701255B
The shift rod guide holds the shift rod bushing.
Application:Part #: 1119027BK
This small fan shroud came on the 36hp motor.
Application:Part #: 111801046K
The heater channel carries heat form the heater boxes to the front of the car.
Application:Part #: 211501283CH
Outer Rear Wheel Bearing, Roller Style Bearing, fits both sides CHINA
Application:Part #: APWGPOSTER
Dunebuggies and Hot VW's Cover Poster of Wolfgang International's Nitro Dragster
Application:Part #: 113863703K
Black Over the Tunnel Floor Mat Black with Foot Rest
Application:Part #: VDO360001
These are the most common sending units.
Application:
This is the front brake rotor that the pads ride against on the disc brake front ends.