Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Gear shift extensions angle back and add about 5" of length to your stock shifter, which allows you to reach the shifter without leaning forward..
Gear shift extensions angle back and add about 5" of length to your stock shifter, which allows you to reach the shifter without leaning forward. With thread pitch of 10x1.5
Bus (Type 2): 55-67
No customer reviews for the moment.
Part #: 211259371A
Fresh Air Lever, Red
Application:Part #: 211837257A
Door check rod pin
Application:Bus (Type 2); 68-76
Part #: 111809085CB
Fastening Panel, Rear Fender
Application:Part #: 113837581EIV
On Bugs up to 1967 and on Buses up to 1963 you will need to push back the small plastic bezel.
Application:Part #: 211405691A
Grease Cap, Left, With Speedo Cable hole
Application:Part #: 211611047FGR
Rear Wheel Brake Cylinder, GERMAN
Application:Part #: 111899117B
This is a little square pad that goes on the torsion housing where the body mounts.
Application:Part #: 1115449BK
Replacement Oil Cap Billet Black
Application:Part #: N185161
These fittings fit on the front end so you can pump grease in the front suspension..
Application:Part #: 311721509
This will replace a worn out pivot for the stock accelerator assembly, to replace this pivot you will have to remove the whole pedal assembly.Make sure you use some white grease on the pin where it mounts to the pedal to insure that it lasts longer..
Application:Part #: 113798078
This is the pin and the spring needed on the accelerator pedal.
Application:Part #: 111198007AF
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 141955517A
This switch controls the wiper motor.
Application:Part #: 1115449OIL
Replacement Oil Cap Billet "OIL"
Application:Part #: 1598021BL
These boots are great for your swing axle because they last longer than stock boots.
Application:Part #: 1070274LK
This rack fits on the roof of your bug and clamps down in the rain gutter.
Application:
Gear shift extensions angle back and add about 5" of length to your stock shifter, which allows you to reach the shifter without leaning forward..