Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:This is the front brake rotor that the pads ride against on the disc brake front ends.
This is the front brake rotor that the pads ride against on the disc brake front ends. Note: When tightening the bearing nut, snug it down against the bearing thrust washer. Now line up the handle of your wrench with one of the lug bolts and back the nut off so the handle of the wrench lines up with the next bolt (a fifth of a turn). Those useing four lug rotors back off just before the next lug bolt. This will prevent bearings from heating up and wearing out.
Bus (Type 2): 73-79
No customer reviews for the moment.
Part #: 211615107A
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle. If you are ordering this without sending your core in first you will need to order the core as well. The core charge will be refunded when we get your core back and it is rebuildable.
Application:Part #: 211615108A
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle. If you are ordering this without sending your core in first you will need to order the core as well. The core charge will be refunded when we get your core back and it is rebuildable.
Application:Part #: 651300420
Suspension Limit Straps 20", Pair
Application:Part #: 113845321FCL
This seal goes around the side window that is stationary (does not have a frame).
Application:Part #: 211611070CGR
Front Right Wheel Cylinder (2 Required) GERMANY
Application:Part #: 211721631B
Accelerator Pedal Lever
Application:Part #: 113853615
These are three little plastic pieces that push into the front hood to hold the emblem in place.
Application:Part #: 6941045
This is the headlight bucket you use in a fiberglass fender of a Baja Bug.
Application:Part #: 361867500
This is the vinyl covering for the inside roof and sides of the Fast Back.
Application:Part #: 211845231
This seal fits in a C channel in the front door frame of buses up to 1967.
Application:Part #: 1105219
This spacer goes between the steel cam gear and the brass distributor gear on the crank.
Application:Part #: 211837606D
Complete Vent Window Assembly, Right
Application:Part #: 1615100
This kit allows you to bolt disc brakes onto your Bug king and link pin or ball joint front end.
Application:Part #: 111905865F
On the back of the switch, you'll normally see three numbers.
Application:Part #: 311133511C
Fuel Filter Square 7mm X 7mm
Application:Part #: 6941043
4" Chrome Offroad Light with 55w H3 bulb
Application:Part #: 211611301CGR
Master cylinder reservoir
Application:Bus (Type 2); 50-65
Offroad/Drag; All