Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:This is the mechanism that makes the window go up and down.
This is the mechanism that makes the window go up and down. Getting the mechanism out is a pain. You will have to start by taking the door panel off and then disconnect the glass from the regulator. Now you're ready for the tough part. The vent wing post has to come loose so look for a bolt holding it to the inner skin of the door. Pay attention to how the regulator is installed in this area, as you will want to put it back the same way. Note: We lay the regulator down flat before installing, squirt some Triflow on the cable and then roll it up and down a few times. This will help the regulator last longer.
Bug (Type 1): 65-67
Off-Road: 65-67
No customer reviews for the moment.
Part #: 113611791
Brake line connector
Application:Part #: 6501149108BO
Overboot Only for 930 CV, Each Offroad applications
Application:Part #: 1823021
This is a dress-up kit for the front and rear air intakes on your bug..
Application:Part #: 6801239
Billet Side Drilled Bracket 2.75" Wide, 1.75" Tubing
Application:Part #: 113707155B
These are the guards on the front and rear bumpers.
Application:Part #: 211611021AAB
This hydraulic cylinder feeds all the wheel cylinders.
Application:Part #: 111955541GY
These are the knobs for the wiper and light switches on the dash.
Application:Part #: 111955408H
The arms extend from the shaft to hold the wiper blades, very rarely do they fail..
Application:Part #: 151845121CL
This seal goes around the front window.
Application:Part #: 113721335A
This cable pulls the arm that releases the clutch.
Application:Part #: 029198175
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 6711149
This box is made so you can weld it to a piece of 1 1/2" tubing and mount it to your shifter.
Application:Part #: 1129201304
Replacement Float for EMPI EPC 32/36A, E, M, EPC 38, Each
Application:Part #: 133133511
This filter goes in line with the fuel line, keeping dirt or rust out of the carburetor.
Application:Part #: 111251261B
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 1117010
This adapter is used to mount an oil filter either by itself or in line with an oil cooler.
Application: