Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
EMPI Single HPMX/IDF Manifold for Type 1 engines
EMPI Single HPMX/IDF Manifold for Type 1 engines
Bug (Type 1): HPMX/IDF
Ghia: HPMX/IDF
Offroad: HPMX/IDF
No customer reviews for the moment.
Part #: 1129610
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 1601153EXT
Replacement Extended Center cap for Sprintstar, Riviera, and 914 rims
Application:Part #: 141881405
Like the door panels, seat covers are a long subject; so here's the basics.
Application:Part #: 2301241
This steel ball replaces the factory plastic one in Bus trannies 1968-1979.
Application:Part #: 1615124A
Left Rear Caliper 5/205 with Emergency Brake, Swing Axle
Application:Part #: 1129027
This raises a stock 28/30PICT carburetor to clear the 12 volt alternator or generator..
Application:Part #: 2129044
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 151845121BCL
This seal goes around the front window.
Application:Part #: 211611070CCH
Front Right Wheel Cylinder (2 Required) CHINA
Application:Part #: 1101146
These cheater studs replace the head studs that have pulled from the case.
Application:Part #: 6401023
These clamps are made to go around your front axle beam and are used when building rail cars or stiffening up the front head of a baja Bug..
Application:Part #: 1501602
We make wheel adapters for some of the more common drums and wheels.
Application:Part #: 211703517
Clutch Cable Tube 1845mm
Application:Part #: 6501281
Billet Aluminum Bearing Cap, Each
Application:
EMPI Single HPMX/IDF Manifold for Type 1 engines