Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
If you like clip on valve covers these are the best that we have seen.
If you like clip on valve covers these are the best that we have seen. They are deeper than stock to clear different rocker arms.
Bug (Type 1): 1200-1600
Bus (Type 2): 1200-1600
Type 3: 1200-1600
Ghia: 1200-1600
Thing: 1200-1600
Race/Off-Road: 1200-1600
No customer reviews for the moment.
Part #: 111101401B
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 311198169A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 11310140105
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1198094A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1198163A
These rings are cast iron.
Application:Part #: 111198057A
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 113101355ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 111198057
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1101448
This is a shim that is used between the head and barrel.
Application:Part #: 1101352
.
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 1198161TS
90.5mm Piston Rings 1.5x2x4 Total Seal
Application:Part #: 1101476BWG
Wolfgang Billet Valve Covers There are a few companys making billet valve covers and I have used a few of them and liked them. But we decided to make our own with a few differences.
Application:Part #: 1198083
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1101356
Whether your motor lives or not can depend upon this little shim.
Application:
If you like clip on valve covers these are the best that we have seen.
