Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This stock oil filler and cap has been chromed.
This stock oil filler and cap has been chromed. Never plug the draft tube! The crankcase relieves it's pressure through the draft tube. If you plug the tube, oil will just blow out somewhere else. Note: Always run a dump tube boot on the end of the tube or your engine will eat dirt. On most off-road cars we put on the oil filler that does not have a down tube. In doing this it is real important that you run a breather filter. We usually run a hose up to the filter and mount it above the engine. On street cars we run the filler that has a tube.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 1117109B
Billett Oil Cooler Block Off
Application:Part #: JC22210
Jaycee Billet Oil Cap with Breater #8 AN Fitting, Red
Application:Part #: JC21030
Jaycee Mag-Plate, 6 Bolt, Blue
Application:Part #: 1117100
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 1115452
This stock oil filler and cap has been chromed.
Application:Part #: 1115107FF
30mm Oil pump for Dual Relief & Flat cam Full Flowed Engines
Application:Part #: 1117008
This adapter is used to mount an oil filter either by itself or in line with an oil cooler.
Application:Part #: JC22270
Jaycee Billet Oil Cap with Breater -10 AN Fitting, Blue
Application:Part #: 1117022
Mesa coolers are the state of the art oil coolers.
Application:Part #: 1117104
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 1115142HD
This oil pump cover comes with a threaded boss.
Application:Part #: 1117698
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:Part #: 113115193
This is the bolt that goes in the plate on the bottom of the motor.
Application:Part #: 1115431
This hex drive replacement plug is for the case relief spring(s).
Application:Part #: 1115140
This plug is used for plugging the outlet passage on an oil pump when full flowing oil pump. 1/4 NPT
Application:Part #: 1115183
This plate is made out of a solid piece of aluminum.
Application:
This stock oil filler and cap has been chromed.
