Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These ride against the cam.
These ride against the cam. We prefer the Mahle or Scat brand for the upright engines. We personally have had bad luck with regrinds. If you are going to use used ones, clean the head surfaces and put two together with the faces touching. Hold them up to a light to see if you can see light between them increasing from the middle out. In other words the heads should be convex not concave or flat. Note: When installing, make sure your cam has .060 to .100" clearance from the top of the cam lobe to the lifter. Install using cam assembly lube.
Bus (Type 2): 2000
No customer reviews for the moment.
Part #: 111198541BR
The cam rides in these bearings.
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:Part #: 113101399B
Rocker Arm Stud
Application:Part #: 021109601
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:Part #: 1109399
1.25 Ratio Rockers ONLY
Application:Part #: 113109623C
These springs return the valves back to their seats.
Application:Part #: 1109341OR
Replacement O-Ring Set 16 pieces
Application:Part #: JC91040
Jaycee Leak proof Pushrod Tubes, Silver
Application:Part #: 021109345A
These are the seals that go around the push rod tubes.
Application:Part #: 1109461
These shims are used under the rockers to set the geometry.
Application:Part #: 1109603
Stainless steel valves are used in the big valve heads.
Application:Part #: 021109349B
These are the seals that go around the push rod tubes.
Application:Part #: 1109405
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: JC91030
Jaycee Leak proof Pushrod Tubes, Blue
Application:Part #: 1109403
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 1109002
Premium Performance Aftermarket Cam Gear
Application:
These ride against the cam.
