Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These gaskets are for upright dual port engines.
These gaskets are for upright dual port engines. Never use any type of sealer on these gaskets. Stock, metal dual port gaskets are junk and only fit well in the garbage can. Sold in pairs
Bus (Type 2): 1700-2000
No customer reviews for the moment.
Part #: 1127112
This regulator adjusts the fuel pressure to you carburator.
Application:Part #: VCP25
This is a rubber plug that is used to plug off vacuum.
Application:Part #: 211129651B
Oil Breather to Air Cleaner Hose
Application:Part #: 1129611
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 021127303A
The fuel pump sits on this little stand and it's also the guide for the push rod.
Application:Part #: 021129637F
We usally find these fittings all taped or glued up.
Application:Part #: 1129604
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 113129729BS
These boots connect the intake manifold with the end casting on a stock dual port 1600cc engine. Two are required boots are sold individually.
Application:Part #: 1129709
This pair of aluminum end castings are for use with a center section manifold.
Application:Part #: 022129707F
The Intake Manifold Gasket (2 are required per engine).
Application:Part #: 1129718
These gaskets are for upright dual port engines.
Application:Part #: 111127521A
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
Application:Part #: 113127025D
These stock pumps pump fuel into the carburetor.
Application:Part #: 021129707D
These are the gaskets used between the intake manifold and the cylinder head.
Application:Part #: 1129612
Single Air Cleaner
Application:Part #: 113129710D
Dual Port Manifold End Casting - Right
Application:
These gaskets are for upright dual port engines.
