Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These rubber mounts hold the transmission in place.
These rubber mounts hold the transmission in place. Check your old mounts while the transmission is in the car. To check the rear mounts, take a pry bar and place it between the saddle and bellhousing and pry up. If the transmission moves, the rear mounts are bad. To check the front mount, place the pry bar between one of the forks and the transmission and pry up. If the nose of the transmission moves, replace the front mount. Stick shift movement on acceleration and deceleration are symptoms of a broken front mount. Note: Don't use solid mounts on the street. The noise that's transmitted through the tunnel will drive you crazy.
Bus (Type 2): 61-62
No customer reviews for the moment.
Part #: 113301263FA
Rear Transmission Mount, Left or Right good quality sold each
Application:Part #: 211711195
Shift Rod Guide Tube
Application:Part #: 211301265A
These rubber mounts hold the transmission in place.
Application:Part #: 113301229A
This is the front of the transmission that houses the shift lever.
Application:Part #: 211599227
Front Transmission Axle Mount
Application:Part #: 111398003
Transmission gasket set.
Application:Bug (Type 1); -60
Bus (Type 2); -59
Ghia; -60
Part #: 111301155
This is the bushing between the bellhousing of the transmission and the starter.
Application:Part #: 001301209
Nose Cone Bushing, Front, Late
Application:Part #: 211501273
This gasket goes between the reduction box halves.
Application:Part #: 001301209C
Nose Cone Seal Holder
Application:Part #: 2301149
Replacement Rubber mounts for Bus mid mount
Application:Bus (Type 2); 56-67
Part #: 002517289A
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 211301215
This is the front of the transmission that houses the shift lever.
Application:Part #: 001301209A
Nose Cone Seal Holder
Application:Part #: 113301155
This is the bushing between the bellhousing of the transmission and the starter.
Application:Part #: 211501249
This large soft plug is on the back side of reduction boxes with the 46mm axle nut.
Application:
These rubber mounts hold the transmission in place.
