Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the front of the transmission that houses the shift lever. Used ones are fine as long as the bushings are good and they're not cracked. Note: Use a new gasket with Gasgacinch for a sealer. Don't over tighten the 11mm nuts. For those of you who are putting a syncro style trans into a 53-59 Bug, you'll need the Bus nose cone and front mount. Those of you with a 60 Bug, punt.
Bug (Type 1): 62-67
Bus (Type 2): 62-67
No customer reviews for the moment.
Part #: 1517122
These diffs add two more spider gears to your differential, plus the housing is way stronger then stock.
Application:Part #: 113701173
This bracket is part of the torsion housing.
Application:Part #: 1301051
High performance street cars or off road cars have been known to crack stock transmission cases.
Application:Part #: 1301049
These straps are a good idea if you have a car with a big engine.The rear strap keeps the bell housing from twisting and the front strap keeps the nose of the transmission from breaking the front mount.We highly recomend that you use these in conjunction with the urethane transmission mounts.
Application:Part #: 1301263
These mounts made of urethane never wear-out.
Application:Part #: 111301255A
Transmission Cradle Mount Bracket
Application:Part #: 1311123
This steel thrust plate stops movement of the main shaft bearing and aids in the keepin the alignment of the gears on the main and pinion shafts.
Application:Part #: 211301265A
These rubber mounts hold the transmission in place.
Application:Part #: 001301083
This seal keeps the fluid in the converter.
Application:Part #: 311301265BFA
Transmission mount, Front
Application:Part #: 001301083B
This seal keeps the fluid in the converter.
Application:Part #: 113301211G
This is the front of the transmission that houses the shift lever.
Application:Part #: 211301215
This is the front of the transmission that houses the shift lever.
Application:Part #: 111398003
Transmission gasket set.
Application:Bug (Type 1); -60
Bus (Type 2); -59
Ghia; -60
Part #: 1301048I
Padded Trans Support Front Kit
Application:Part #: 001301209C
Nose Cone Seal Holder
Application:
