Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
We have found this kit to be a good, cheap dual carb kit for a stock motor.
We have found this kit to be a good, cheap dual carb kit for a stock motor. Throttle bushings wearing out over time is the only bad thing we can say about them. We suggest you change the fuel hose in the kit to German hose. *Part numbers ending in an E are reproductions of Weber Carb Kits by Empi.
Bus (Type 2): 1700-2000
No customer reviews for the moment.
Part #: 1129508
These are some of the most common jets used.
Application:Part #: 113129191G
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 1129505007
These are some of the most common jets used.
Application:Part #: 1129506PRO
Velocity Stack Covers, for 48IDA/EPC 48 & EPC 51 Carbs, Pair Inside Diameter is 3.850"
Application:Part #: 1129201300
EPC 48/51 3.0 Needle and Seat IDA 300
Application:Part #: 1129044
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 112950505IDF
Throttle Shaft Lock Tab Washer for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 112950504IDF
Idle Jet O-ring for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129044E
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129040E
We've found that dual carbs work better than any single carburator set up.
Application:Part #: N137761
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 112950503IDF
Cupwasher for Idle Jet O-ring for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 113129031EMP
This is what delivers gas and air to the engine.
Application:Part #: 1129199150
Needle Valve for 40/44 HPMX (EMPI), 40-48 IDF (Weber) 1.50mm
Application:Part #: 1129026
34 Pict Carburetor spacer plate, measures 3/8" thick with 2 11/16" hole to hole
Application:Part #: 113129027
This is what delivers gas and air to the engine.
Application:
We have found this kit to be a good, cheap dual carb kit for a stock motor.
