Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Here are some of the replacement parts for your stock carburetor. Sold individually.
Here are some of the replacement parts for your stock carburetor. Sold individually.
No customer reviews for the moment.
Part #: 1129505011
These are some of the most common jets used.
Application:Part #: 1129510A
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129139
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 113198575URP
This kit comes with the gaskets, the needle and seat, and accelerator pump diaphragm for the carburetor..
Application:Part #: 1129310
Empi Idle Jet Vent Tube Kit
Application:Part #: 1129199175
Needle Valve for 40/44 HPMX (EMPI), 40-48 IDF (Weber) 1.75mm
Application:Part #: 113129027EMP
This is what delivers gas and air to the engine.
Application:Part #: 1129044
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 211129493
Steel Vacuum Line junction between Vacuum Advance and carburetor
Application:Part #: 112950503IDF
Cupwasher for Idle Jet O-ring for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129506PRO
Velocity Stack Covers, for 48IDA/EPC 48 & EPC 51 Carbs, Pair Inside Diameter is 3.850"
Application:Part #: 1129516
Empi Hex Bar Linkage Bearing Conversion Kit
Application:Part #: 049129412C
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 1129039E
Empi Dual 40mm Carburetor complete setup
Application:Part #: 112950505IDA
Stack Hold Down Tab
Application:Part #: 112950504IDF
Idle Jet O-ring for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:
Here are some of the replacement parts for your stock carburetor. Sold individually.